Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
VR setup
#1
Since I need a VR setup for Cranksensor I looked at the drawings (22jan 2016Rev:0.1-alpha Git: 88f6dde)
PCB Git nr and Drawing Git nr are the same.
Page 2/7 Crankshaft an Camshaft inputs.

There is this text "R20 and R23 are only to be used with VR inputs.........."

Where do I find these on the drawing/board ?
Reply
#2
Let me ping CoolEFI.
Reply
#3
(01-08-2017, 11:58 AM)LAV1000 Wrote: Since I need a VR setup for Cranksensor I looked at the drawings (22jan 2016Rev:0.1-alpha Git: 88f6dde)
PCB Git nr and Drawing Git nr are the same.
Page 2/7 Crankshaft an Camshaft inputs.

There is this text "R20 and R23 are only to be used with VR inputs.........."

Where do I find these on the drawing/board ?

The R20 and R23 designations were left over artifacts from the JAGuar DIY EFI PCB design, they were re-assigned designations of R17 and R18 and are located on the back side of the CoolEFI Basic ECU to the right of the LOAD jumper block.
Reply
#4
(01-09-2017, 10:43 AM)s10andy Wrote:
(01-08-2017, 11:58 AM)LAV1000 Wrote: Since I need a VR setup for Cranksensor I looked at the drawings (22jan 2016Rev:0.1-alpha Git: 88f6dde)
PCB Git nr and Drawing Git nr are the same.
Page 2/7 Crankshaft an Camshaft inputs.

There is this text "R20 and R23 are only to be used with VR inputs.........."

Where do I find these on the drawing/board ?

The R20 and R23 designations were left over artifacts from the JAGuar DIY EFI PCB design, they were re-assigned designations of R17 and R18 and are located on the back side of the CoolEFI Basic ECU to the right of the LOAD jumper block.
Those are the ones I have to change to something between 100-10kOhm I did find them.
Also need to change/check R8,R9,R12, and R13 to 10kOhm.

Thanks
Reply
#5
You should also verify the VR polarity, if you can.
Reply
#6
Do we need it this way or inverse ?


Attached Files Thumbnail(s)
   
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)